MENGAPA HARUS MELALUI PROSES RECYCLING... .
Banyak perusahaan mengatakan proses recycling ini membutuhkan waktu dan anggaran lebih, mereka lebih suka hanya memasukkan waste material ke dalam crusher, menjadikan serpihan kecil lalu di masukan ke mixer dan langsung masuk ke proses produksi kembali. Padahal proses sederhana itu akan membuat kinerja mesin lebih berat (karena tingkat parameter yang berbeda) dan bisa membutuhkan energi lebih banyak dan waktu proses produksi lebih lama (untuk injection dan blow) dan tingkat output lebih rendah (untuk film), material yang tidak merata yang dikarenakan perbedaan size material yang masuk ke dalam extruder, bahkan tingkat keausan screw dan barrel yang cukup tinggi, sehingga biaya yang dikeluarkan akan jauh lebih tinggi.
Juga banyak perusahaan tidak bisa mengoptimalkan value dari waste material, walaupun sedikit atau banyak, namun sangatlah berharga apabila seluruh waste material bisa dipergunakan semaksimal mungkin.
WHY IT MUST GO THROUGH RECYCLING PROCESS... .
Lots of companies say this recycling process is more time consuming and needs more budget, so they prefer only putting the waste material into crusher, making it small pieces, then thrusting it to mixer, and immediately stepping into production process again. Where as that simple process will make the work load of machine heavier (since the parameter level is different), more over it can cause more energy, production process time becomes longer (for injection and blow), and the output level gets lower (for film), inequitable materials which is caused by the difference of size materials that are put into extruder, even makes the level of worn-out of screw and barrel quite high, so that the expense will finally be more costly.
Many companies cannot optimize the value of the waste materials as well, no matter how little or how much they are, howwer it is so valuable if all the waste materials could be used as maximum as they could be.
Anugrah Damai Abadi Polyester ( ADAPoly ) : 1 3
